Minié system - The "Rifled Musket"

Minié system - The "Rifled Musket"

French-made Minié rifle used in Japan during the Boshin war (1868-1869).

 Main articles:Minié ball and Minié rifle

     One of the most famous was the Minié system, invented by French Army Captain Claude Etienne Minié, which relied on a conical bullet (known as a Minié ball) with a hollow skirt at the base of the bullet. When fired, the skirt would expand from the pressure of the exploding charge and grip the rifling as the round was fired. The better seal gave more power, as less gas escaped past the bullet, which combined with the fact that for the same bore (caliber) diameter a long bullet was heavier than a round ball. The extra grip also spun the bullet more consistently, which increased the range from about 50 yards for a smooth bore musket to about 300 yards for a rifle using the Minié system. The expanding skirt of the Minié ball also solved the problem that earlier tight fitting bullets were difficult to load as black powder residue fouled the inside of the barrel. The Minié system allowed conical bullets to be loaded into rifles just as quickly as round balls in smooth bores, which allowed rifle muskets to replace muskets on the battlefield. Minié system rifles, notably the U.S. Springfield and the British Enfield of the early 1860s, featured prominently in the U.S. Civil War, due to their enhanced power and accuracy.

     Over the 19th century, bullet design also evolved, the bullets becoming gradually smaller and lighter. By 1910 the standard blunt-nosed bullet had been replaced with the pointed, 'spitzer' bullet, an innovation that increased range and penetration. Cartridge design evolved from simple paper tubes containing black powder and shot, to sealed brass cases with integral primers for ignition, while black powder itself was replaced with cordite, and then other nitro-cellulose-based smokeless powder mixtures, propelling bullets to higher velocities than before.[2]

     The increased velocity meant that new problems arrived, and so bullets went from being soft lead to harder lead, then to copper jacketed, in order to better engage the spiraled grooves without "stripping" them in the same way that a screw or bolt thread would be stripped if subjected to extreme forces.